跳到内容 
Getting the hang of Epoxy Spike Shoes is all about balance and timing.
How to Use Epoxy Spike Shoes
Spike shoes allow you to walk directly onto wet self-leveling underlayment or epoxy coatings to spread material or use a spiked roller without leaving permanent footprints.
- Preparation (Before Mixing)
Assembly: Most shoes come as a kit. Securely fasten the steel spikes to the base plates using a wrench. Ensure they are tight so they don’t wobble.
Fitting: Strap the plates over your regular work boots. Pull the nylon straps or Velcro tight through the D-rings. If they are loose, you’ll lose balance or trip.
The “Safety Check”: Walk on a hard, dry surface first to ensure the straps are snug and the spikes are even. - Application Technique
Entry: Wait until the material is poured and spread. Step onto the wet surface slowly.
The “Spike Walk”:
Keep Feet Flat: Lift your feet straight up and set them straight down. Do not drag your feet or “shuffle,” as this will create gouges in the material.
Steady Pace: Walk at a calm, consistent speed. Avoid sharp pivots or sudden stops.
Work Flow: While walking, use your Spiked Roller or squeegee to level the surface and remove air bubbles behind you as you retreat toward the exit. - Critical Tips & Maintenance
Timing is Everything: Only walk on the material while it is in its “liquid phase.” Once it begins to “gel” or get sticky, stop walking immediately, or the spike marks won’t heal.
Cleaning: Clean the spikes immediately after use with an appropriate solvent (like Xylene or Thinner for epoxy) before the material hardens. Dried epoxy is nearly impossible to remove.
Safety: Never wear these on stairs or slick, dry concrete—they turn into ice skates!
